Adding Accounts to Bank Feeds (Intacct)

use this guide to add and configure bank feeds for new accounts, assuming you already have bank feeds enabled for existing ones for example, you might have recently added new bank accounts to the plugin and now need to set them up for easier reconciliation set up multi account bank feeds bank feeds allows you to connect multiple accounts to the plugin once one bank account has been connected to bank feeds by following the enabling bank feeds page, other accounts can be connected simultaneously through a financial institution connection note before you set up the financial institution, ensure that both cash management and sage cloud services are enabled in the subscriptions section in the sage cloud services configuration, confirm the enable bank feeds checkbox is checked as per the enabling bank feeds page if this does not work, please contact sage support and ask to get access to the financial institution follow the steps below to set up multiple accounts for bank feeds set up a financial institution go to cash management → set up → financial institution and create a new financial institution this allows you to create a connection to the bank create the id and name as desired map accounts for bank feeds select map accounts and choose which accounts you would like to enable on bank feeds note you must complete account matching within 60 minutes; otherwise, the installation wizard will time out, the connection will fail, and the account will remain pending with no transactions coming in to retry, disable the account(s) under the accounts table and reinitiate the mapping process if there are more than 100 transactions, the plugin will upload them into the system in batches of 100 this may cause some transactions to appear initially, while others will appear later typically, it takes a few hours to view all your transactions after mapping the accounts, the banking cloud statuses can be seen in the accounts tab to view your account information, click bank transactions in the cash management module you can also view this information through the reconciliation module